Good points, Cliff. Thanks for the idea!
D
-----
Cliff Shaw wrote:
>
> D Wysong
>
> I worried about that too. I did not find good references as to what I should
see if I did install spark plug sensors.
>
> The real question you need answered is "what is the H2O temperature" This is
the "hotspot" in the Rotax 912S. (you don't wnat it boiling over) I installed
a probe in the "coolant pot" using a alum nipple I had welded to the pot.
Now I read the hot water temp on CHT . ( just like oil temp)
>
> My thoughts.
>
> Cliff Shaw
> 1041 Euclid ave.
> Edmonds, WA 98020
> 425 776 5555
> http://www.europaowners.org/WileE
>
>
> ----- Original Message -----
> From: D Wysong
> To: europa-list@matronics.com
> Sent: Thursday, January 19, 2006 3:47 PM
> Subject: Europa-List: part #'s for CHT probes?
>
>
>
> I saw this question a few times in the archives but never stumbled upon
> an answer...
>
> Anyone have a part number for CHT probes that have been successfully
> installed underneath the spark plugs of a Rotax 914?
>
> What other methods have you all used to measure all 4 CHTs on a 914?
> (... or CHTs for 1 and 4 if using the VDO probes on 2 and 3)
>
> Thanks!
>
> D
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
|