Hi! Jeremy.
I used a length of square section door knob bar cut off very close to one of
the holes. Insert the end of the hinge pin in the hole at the end and bend
over to required angle and direction.
Regards
Bob Harrison G-PTAG
-----Original Message-----
From: forum-owner@europaclub.org.uk
jeremycrdavey@btinternet.com
Subject: Bending hinge pins
Has anyone out there got a neat trick for bending the hinge pins? They're so
stiff I'm rather nervous of bending or damaging the hinge as well, and the
only
tool I've found that makes any impact on the pins is a large hammer.
Regards,
Jeremy
Jeremy Davey
Europa XS monowheel 537M
|