Temperature is going to be the controlling factor here. The outer skin may or
may
not be ruined. The inner structure you definitely don't want to over heat.
You might want to get a Templstick for a weld supplier. The come in various temp
ranges. You draw on the part with it like a crayon and when the part hits the
templsticks temp it melts.
This would give you precise temp control of the surfaces.
Chat Later,
Steved
----------------
This Email contains Photos or Attachments located at the following link:
http://www.europaowners.org/viewtopic.php?p=9287#9287
----------------
|