My experience is that you need to lay it on thick in the middle of the bond
and then ensure that it squeezes out the sides. This avoids having voids
in the bond. I spent quite a lot of time with a high power light, a 1/8
drill and a syringe after my first bonds.
Will
William Daniell
LONGPORT
+57 310 295 0744
On Wed, Jan 24, 2018 at 8:05 PM, Graeme Hart <graeme.hart@onecoolkat.com>
wrote:
> No I mean 6 kits. I don't know what a quart is in terms of weight but the
> "Part A" of the packs I have is 1kg which is about 2.2 pounds.
>
> I'd rather have too much than too little as the cost of shipping exceeded
> the cost of the adhesive and the cost of shipping was largely independent
> of the amount of adhesive I was shipping (due to dangerous goods paperwork,
> special packaging, handling etc)
>
> If I was in your position I'd take the risk and just go ahead with the
> adhesive you have and consider ordering more once the cockpit is in and one
> wing is closed.
>
> It does seem like I've got an excessive amount of adhesive so I may have
> some to sell in a year or so.
>
> On Thu, Jan 25, 2018 at 12:00 PM, n7188u <chmgarb@gmail.com> wrote:
>
>>
>> Thanks,
>>
>> I assume that by six cans you mean 3 quart kits. I was told 3 quarts is
>> what is supplied in the kit. I am hoping to get a very rough estimate of
>> the amount needed for the three stages I mentioned. Just in terms of half
>> can, quarter can, etc.
>>
>> Sounds like a weird request but it will help me keep the cans closed
>> until the moment they are needed (this stuff is like gold so might as well
>> keep it as such!).
>>
>> Chris
>>
>>
>>
>>
>> Read this topic online here:
>>
>> http://forums.matronics.com/viewtopic.php?p=477552#477552
>>
>>
>>
>>
>>
>>
>> ===================================
>> pa-List" rel="noreferrer" target="_blank">http://www.matronics.com/
>> Navigator?Europa-List
>> ===================================
>> FORUMS -
>> eferrer" target="_blank">http://forums.matronics.com
>> ===================================
>> WIKI -
>> errer" target="_blank">http://wiki.matronics.com
>> ===================================
>> b Site -
>> -Matt Dralle, List Admin.
>> rel="noreferrer" target="_blank">http://www.matronics.com/contribution
>> ===================================
>>
>>
>>
>>
>
|