Rowland,
I used a small plastic P clip to connect it to the underside of the CD7 (CBM-XS
914 Installation Manual, page 4-6) with the wiring passing through the same
grommet
as the Wastegate Cable.
I will be working on the Europa tomorrow. With any luck Ill remember to take a
picture for you.
Blue skies & tailwinds,
Bob Borger
Europa XS Tri, Rotax 914, Airmaster C/S Prop (50 hrs).
Little Toot Sport Biplane, Lycoming Thunderbolt AEIO-320 EXP
3705 Lynchburg Dr.
Corinth, TX 76208-5331
Cel: 817-992-1117
rlborger@mac.com
On Feb 22, 2014, at 4:44 PM, Rowland Carson <rowlandcarson@gmail.com> wrote:
I'm wondering where to put my outside air temperature (OAT) sensor. Obviously it
doesn't want to be in direct sunlight (although PA28s seem to think that's OK),
and not anywhere on the belly downstream of the exhaust. Does anyone have
a good suggestion for it? It's tiny, less than thumbnail size, so doesn't need
much room, and the wires back to the panel can be as long as needed.
in friendship
Rowland
| Rowland Carson ... that's Rowland with a 'w' ...
| <rowlandcarson@gmail.com> http://www.rowlandcarson.org.uk
| Skype, Twitter: rowland_carson Facebook: Rowland Carson
| pictures: http://picasaweb.google.com/rowlandcarson
|