Ron...see indented comments below...Fred
On Jul 29, 2013, at 12:14 AM, rparigoris wrote:
> Now I'm having a hard time figuring out how I can remove the FL18P + S
that are stuck to the piece of wood and get it back to this perfect
registration after gooped up with Redux/flox.
I used either a dab of bondo or some hot glue to bond
the FL18s to the piece of wood...a light tap on a chisel separated them
in a jif.
>
> What I'm proposing is when everything is in perfect alignment, sneak
the FL16s in place, being careful to not change the perfect
registration, and bolt the FL18s to the FL16s, then Bondo the FL16s to
the fuse. Now I have the pivot holes of the FL16s in the perfect
position too.
>
> I can then remove the FL18s that are bonded to the piece of wood, goop
them up with Redux /flox, then when I set in place, I will again insert
the bolts between the FL18s and FL16s and I should have the FL18s in
perfect position for the cure?
I believe using the string...especially w/ your clever
centering machinement...is a more accurate way to ensure alignment than
to rely upon the bolts...but use your own judgement.
In my case, I did NOT remove the FL18s from the piece of
wood until AFTER they were reduxed and cured in final position.
Good luck,
Fred
|