Hi all,
This is about a Europa XS with the 912S and the oval exhaust silencer.
2 years ago I had a burned coolant hose (to cylinder 2) because the hose runs
too
close over the exhaust. This was a very scaring experience because it happened
just after take-off at low altitude. So the replacement was well protected
with heat shielding. But doing so makes the o.d. larger and therefor the
heatshielded
hose is actually quite heavily pressing on the silencer.
Now I like to solve this properly and I plan to cut the 2 rear downstacks to
allongate
them by 1-2 cm. But before doing so I would like to know if others recognizes
this lack of space too. I hardly can imagine that my Europa is the only
one with this problem, but I could not find a topic about it in this forum.
So any suggestions how others have solved it, or reasons why not to cut the rear
stacks are most welcome.
Kees de Bussy
Europa XS TG PH-SBR
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=366709#366709
Attachments:
http://forums.matronics.com//files/waterslangen_portside_125.jpg
|
