Hi! William D
There should be a template of the wing profile in the appendix of your
build manual which when produced in strong cardboard will provisionally
locate the stall strip position to enable flight testing to fine tune
the final fixing point. Mine shake the aircraft but good at the
appropriate time, busy making decisions or not you couldn't ignore it!
Regards
Bob H G-PTAG
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of William
Daniell
Sent: 20 June 2007 23:37
Subject: RE: Europa-List: Re: 180 turns
<wdaniell@etb.net.co>
Ah again displaying my ignorance..."properly adjusted stall strips".
How do
you go about adjusting them?
|