Hello Terry,
Congratulations for your web site it is very interesting.
Why you don't used a carburetor cups I think it is good for safety if
unleaded run up to the carb. If you are interested I have drawings for
cups mod (because skydrive heater)and many others mods drawings.
Do you have drawings of your monowheel gear leg support stand?
--|--
--------(*)--------
Michel AUVRAY N145
-----Message d'origine-----
De : owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] De la part de Terry
Seaver
Envoy : jeudi 27 janvier 2005 01:01
: europa-list@matronics.com
Objet : Re: Europa-List: Tailplane Balance
Hi Jim,
After the tailplanes have been painted, some of the mass balance weight
has to be cut off. Some people have cut their weights into many pieces
of varying size/weight, and then iteratively tried combinations until
the tailplanes balanced.
We used a more deterministic method, which only required a single cut to
get good balance. The procedure can be found in our 'Europa Mods and
Building Tips', a copy of which can be seen at:
http://terryseaver.home.comcast.net/europa_page.html
entitled 'Tailplane mass balance procedure'
regards,
Terry Seaver
Jim Butcher wrote:
>
> Can someone point me to where the manual gives instruction for
> adjusting the tailplane mass balance. Chapter 20 merely says the
> final position of the weights will be determined after the tail planes
> are painted.
>
> Thanks
>
> Jim & Heather A185
> XS 914 short wings
> paint done, electrical about done, ready to hang engine
>
>
>
>
>
|