A simple question for all those ahead of me:
The instructions say that you cut out the wheel well on the underside of the
fuse along the edges of the bonded in cockpit module. You cut it back 31
inches from the firewall.
I notice from photos that the end of the cutout is curved to match the tyre
itself. If I cut back 31 inches, will I have to cut further to get the
curve (good answer) or will I have to cover in bits of the cut out around
the tyre (bad answer, patching up bits that need not have come out in the
first place)?
John Bampfylde, #130
|