Subject: | Re: Trailing Edge Finish |
---|---|
From: | Graham Singleton <100421.2123@compuserve.com> |
Date: | Tue, 6 Feb 1996 17:48:45 |
The current opinion on trailing edges seems to be that they should be square, not rounded. There is even a figure mentioned for maximum thickness but I can't remember what it is or where I read it. Between 1/16" and 1/8" is easier to make, less fragile than knife edge and some say reduces stick loads. BTW,I'm not from the factory but I don't think they will argue. Graham |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: Hints and Tips - Bowed foam blocks, Duncan McFadyean |
---|---|
Next by Date: | Re: Pondering your brake/puncture problem, Graham Clarke |
Previous by Thread: | Re: Trailing Edge Finish, Martin J . Tuck |
Next by Thread: | Re: Trailing Edge Finish, Graham E Laucht |
Indexes: | [Date] [Thread] [Top] [All Lists] |