This shrink-wrap may be of some value for reducing comm noise...came
across it in McMaster catalogue
A layer of cloth shielding protects your unshielded wire or cable
from EMI/RFI. Use on shielded wire or cable for added protection or
for coverage at the terminal where an existing shield has been
stripped back for the connector. Tubing is black polyolefin. Note:
For proper grounding, a conductive wire (see pages 782-784) or braid
strip (see page 910) should be wound around the outside of wires or
attached by solder or conductive epoxy (see page 3340)
http://www.mcmaster.com/#catalog/115/797/=sesag
Fred
A194
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.