Hi Martin,
I too have both of my servos near each other. I ran only one wire bundle per the
manual, as if you were installing only one servo. However, at the servo end
I made a daisy chain so that I could extend the wire harness to the other servo.
Then you only need one yellow disconnect wire run to a single switch on your
panel or stick. Hope that makes sense.
Erich,
N28ET ClassicMono 914
____________________________________________________________
Unbelievable German World War 2 Photo Shocks Americans
pro.naturalhealthresponse.com
http://thirdpartyoffers.juno.com/TGL3131/5af06cfa753ba6cf86b78st01duc
|