Le 17/03/2018 20:58, Remi Guerner a crit:
>
> The G5 Manual recommends the GA26C among others for non certified G5
> installation.
Understand.
>
> On the Europa you need to remove the whole panel module to do that.
Ouch !
Any slack in the wiring to allow behind-the-panel access without too
much hassle ?
> So better do it right on the first try!
Then as advised, keeping the excess length neatly stored in a loop seems
the way to go.
Please note that to minimize interference issues, the smaller the area
of the loop the better. That is while preserving safe bending radius for
the coax.
You can also twist the loop in a figure 8 without stressing the coax.
See https://support.agleader.com/kb_upload/image/coax4.jpg.
All the best,
--
Best regards,
Gilles
http://contrails.free.fr
http://lapierre.skunkworks.free.fr
|
