Hi All
I am just about to tackle fitting the doors.
After reading the build manual 12 times and Bud's excellent 'Door Fitting'
article
several times, I am pretty sure I know what I need to achieve.
However, a couple of questions before I set to it with the Permagrit block:
1. What sort of gap am I trying to get between the door flange and the fuselage
recess? A mixing stick? or a bit more?
2. Is it a good idea to slightly round off and lose the sharp edge off the
inner
and outer edges of the door flange to prevent paint flaking and chipping?
Also, I am assuming that all door fitting is completed before fitting any door
seals.
--------
Regards
Kelv Weston
Kit 497
kelv@kdweston.biz
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=472990#472990
|