David,
Bing Carb CHOKE NIPPLES - Nipple 276 855 available from Rotax
distributors ($53.40 from Lockwood here in the U.S.)
Carb heat water jackets - Carb Heater No Part No. available from Rotax
distributors ($415.00 from Lockwood here in the U.S.)
Exhaust copper plated nuts - 8mm exhaust hex nuts 842 950 are available
---From Rotax distributors ($1.19 from Lockwood here in the U.S.)
Engine Monitoring System - Grand Rapids EIS 4000 for Rotax (~$900, basic
or ~$1300, advanced) from Grand Rapids, Aircraft Spruce, etc.
Perhaps a wobbly prop - Airmaster Propellers from Airmaster or local
Airmaster rep.
Here in the U.S.A. Rotax bits and pieces are available from a number of
vendors. Lockwood.aero is my go-to. There are a number of others.
You=99ll have to find your own in the UK.
Grand Rapids makes a good engine monitor. I have installed it on a
couple of Lycomings and I have one on my Europa/Rotax 914UL and it works
just jim-dandy. It is available form Grand Rapids (grtavionics.com
<http://grtavionics.com/>) or various resellers like Aircraft Spruce
(aircraftspruce.com). There=99s probably a reseller in the UK.
It can be a bit of a pain to learn to use unless you connect it to a
graphical interface (i.e. one of the GRT EFIS). I=99m less
familiar with the Dynon offerings but they seem to work well also.
I like the Airmaster C/S propeller. It works well, is easy to use, easy
to install, surprisingly light for a C/S prop. It is an electric prop
rather than hydraulic. Which is one reason it is so light.
airmasaterpropellers.com <http://airmasaterpropellers.com/>
I hope this helps. Let me know if you need further information.
Blue skies & tailwinds,
Bob Borger
Europa XS Tri, Rotax 914, Airmaster C/S Prop (75 hrs).
Little Toot Sport Biplane, Lycoming Thunderbolt AEIO-320 EXP
3705 Lynchburg Dr.
Corinth, TX 76208-5331
Cel: 817-992-1117
rlborger@mac.com <mailto:rlborger@mac.com>
On Jan 10, 2017, at 1:36 PM, G-ODTW <dave@robotas.co.uk> wrote:
If anyone has a list of materials they have used, it would be very
helpful to many folk. The following fields would make it invaluable:-
Part Number
Description
Cost
Supplier
Maybe with comments like "don't touch with a barge-pole" or " works a
treat!".
Perhaps such a thing already exists, but I have not found it yet. . . .
Currently I am trying to source :-
Bing Carb CHOKE NIPPLES
Carb heat water jackets
Exhaust copper plated nuts
Engine Monitoring System
Perhaps a wobbly prop
--------
David Walters
01474 816817
dave@robotas.com
|