Hi All.
So 6 amps is OK, i am not a builder so don,t have odd pieces of alloy laying
around
so had to use an old plate i found, i have made my little panel and fitted
it in place, also made a little CB panel, to connect it to. Sometime i will
get round to wiring it up,so a couple of questions.
The switches are 6 amps at 135v AC so i am limiting the Aux power sockets to
6 amps each by an in line fuse. I am not sure if the switch would take 10 amps
at 12 volts ? 6 or 10 ?
The usage will be, phone, ipad, inspection lamp, tyre pump,
I intend to put the 2 x in line fuse on the (live + wires) BEFORE the switches,?
The Starter Button, is 6 amps, and power switch also 6 amps, flip the switch and
the START BUTTON illuminates in RED,then Press for start.
Does anyone have the Rotary Mag key starter switch, because i need the starter
relay wire from this switch, i take it that its is single pole so just the two
wire to be taken over to my new switch, which two.?
This will now give me independent mags, for engine starting.
Later the Soft Start module this is only 20 minutes to fit if you have separate
mag switches, its the easy bit.
Alan
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=395212#395212
|