Morning Alan
I would think so. The starter switch circuit should be protected by a 2 amp
CB according to the manual.
My switch is nothing like as good as that one. Looking at the spec these
are clearly intended for vehicle use so should be fine. You must have
bought the last one the RS website is now showing your link as back order
shipping 15 April.
Another grey and damp morning up here. Glad I got a fly on Saturday it has
not been fit since.
My mate at Goodwood got a go in an Extra 330 on Sunday. He timed the take
off - 4 seconds from start of roll to airborne at 70 kts. Mind you it is a
540 cu in engine that is 9.55 litres! Said it was a lovely aeroplane to fly
even if you could not see where you were going.
Pete
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of Alan Carter
Sent: 27 February 2013 01:54
Subject: Europa-List: Stater Relay is 6 amps switch OK
starter motor.
I want to install a separate starter button, i have purchased a press button
switch, rated at 6 amps @ 12 v and 6 amps @ 250v
Is this OK.
The switch spec.
http://uk.rs-online.com/web/p/push-button-switches/6915242/?
Alan
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=395139#395139
--
This message has been scanned for viruses and
dangerous content by Houxou, and is
believed to be clean.
|