Carl,
The ultimate ventilator shown below could be installed easily in your plane.
Not sure about your approval to do so and all. I installed them just below t
he windscreen, above the fuselage jogle, as close to the panel module as pos
sible. They are above my knees and I like the way they are infinitely adjust
able. Plenty of air when you want it.
I have seen them installed in the lower corner of the windscreen itself, too
.
Kevin
On Aug 13, 2012, at 3:46 AM, "G-IANI" <g-iani@ntlworld.com> wrote:
> Carl
>
> The mod Bruno describes is documented on our web site (http://www.theeurop
aclub.org/wp-content/uploads/2011/12/G-MIME-Vents.pdf). It is PFA/LAA appro
ved but at present LAA cannot find the paperwork (or even a number for it).
>
> The ultimate vent is nice (see picture) but expensive.
>
>
> Ian Rickard G-IANI XS Trigear, 300hours
> Europa Club Mods Specialist
> e-mail g-iani@ntlworld.com
>
>
> From: owner-europa-list-server@matronics.com [mailto:owner-europa-list-ser
ver@matronics.com] On Behalf Of Carl Pattinson
> Sent: 13 August 2012 00:08
> To: europa-list@matronics.com
> Subject: Europa-List: Fresh air Vents
>
> Hi,
>
> Does anybody have a mod/ design for a vent that can easily be fitted to an
existing installation.
>
> I believe the front screen is a structural component so can=99t be a
ltered but presumably the side screens could have a vent installed.
>
> I believe that Spruce and Speciality sells design that can simply be bolte
d into a circular hole cut through the Perspex.
>
> For obvious reasons an approved mod would be preferred.
>
> Thanks
>
> Carl Pattinson
> G-LABS
>
>
> No infections found in this outgoing message
> Scanned by iolo System Shield=C2=AE
> http://www.iolo.com
>
>
> http://www.matronics.com/Navigator?Europa-List
> http://forums.matronics.com
> http://www.matronics.com/contribution
>
> <Ultimate Vent.jpg>
|