X-mailer: iolo System Shield 10.7.6.60
Hi Ian,
Unless I am much mistaken, Graeme is fitting a Woodcomp assembly - not
Airmaster.
I just had a look at the figures when I changed from a tapered blade Warp
drive to my Woodcomp SR3000.
Warp Drive (with spinner) 4.9kg.
Woodcomp (with spinner) 12.5 kg
However I believe Graemes Warp prop is not the tapered variety (bigger
engine) and his Woodcomp is a later spec than mine (mine is all wood -
Scimitar shape). Figures should be similar though.
Cheers,
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of G-IANI
Sent: 12 June 2012 11:09
Subject: RE: Europa-List: Weight of HPL 3 blade warp drive prop for ref
Graeme
I am not sure exactly what it is you are quoting the weight of. The numbers
you give seem wrong to me.
The weight of an Airmaster AP332 setup is 11.8Kg for the prop and 0.6Kg for
the controller (Total 12.3KG = 26.6Lb). You will find this quoted on page 3
of the Airmaster brochure:-
http://www.airmasterpropellers.com/Portals/0/Products/Systems/Airmaster-broc
hure-332.pdf
I have one here, not yet on the aircraft, if you want me to check.
Ian Rickard G-IANI XS Trigear, 300hours
Europa Club Mods Specialist
e-mail g-iani@ntlworld.com
_______________________________________
No infections found in this incoming message Scanned by iolo System Shield.
http://www.iolo.com
_______________________________________
No infections found in this outgoing message
Scanned by iolo System Shield
http://www.iolo.com
|