Phil,
>From the Mod PDF:
Stainless Tube (0.375outsidediameter,0.3125insidediameter) The inside of the
stainless
tube is the critical dimension so that it provides a sliding fit for the
AN5 bolt. A slightly larger outer diameter is acceptable which will require
a larger hole in the OR1.
Blue skies & tailwinds,
Bob Borger
Europa XS Tri, Rotax 914, Airmaster C/S Prop.
Little Toot Sport Biplane, Lycoming Thunderbolt AEIO-320 EXP
3705 Lynchburg Dr.
Corinth, TX 76208-5331
Cel: 817-992-1117
rlborger@mac.com
On Jan 13, 2012, at 8:07 AM, flyingphil2 wrote:
>
> Roddy / Graeme,
>
> I believe that I've found the stainless tubing offcut that I used for this.
Can you remind me of the ID and OD so that I can measure it and check. I do
remember
having to turn one diameter down on a lathe but I can't remember which
one.
>
> Regards,
>
> Phil
|