Remi I had one cable fail right under the metal clamp due to vibration. That
is a bad design because the cable can vibrate free for about 8 cm and then
is hold very tight with that clamp.
I replaced that part of the cable with teflon coated and applied a few more
fasteners to prevent strong vibrations. Also, I de-vibrated the prop which
was a major step forward !
Also check other sources such as the health of the ignition modules and the
hall sensors on the back of the engine.
All the best,
Thomas, N81EU
----- Original Message -----
From: "Guerner Remi" <air.guerner@orange.fr>
Sent: Monday, May 23, 2011 9:22 PM
Subject: Europa-List: urgent: 912S ignition failure
>
> Hello,
> I have an intermittent ignition failure on both channels A and B. After
> many hours of investigation I am now suspecting the wiring to and from
> the ignition modules. My question is to those who have experienced
> ignition failure caused by broken wires in the ignition system. Which
> wire was broken and where?
> Regards
> Remi Guerner
>
|