Well for those almost up to this stage, heres what I opted for, and it seems
to work nicely
I carefully drilled a series of tiny holes about 1cm apart every 50mm or so
along the offending
twisted sections and then used small pieces of stainless tie wire ( the
stuff you all have for
securing all those safety wired nuts and bolts) and wired a mixing stick to
the outside of the plexi
pulling the wire tight from the inside. Later the glued in wire can be
easily removed by heating the
wire with a soldering iron from the inside if it is really stuck.
hope this helps those that are fighting their windows
craig
|