Martin,
When you power up EIS, the red light comes on flashing, correct?
And when it does, the page showing has Oil Press on it and that value is
blinking,
correct?
And when you push ACK, the light quits blinking but stays on steady and the
default
display page (usually fuel qty & flow display page 0) comes up, correct?
Then you start up and the light stays on, not blinking, correct?
If all these are true, the problem is in the oil press low/high limits or the
pressure
measurement. Be aware there are two low oil press settings - one is Min
OilP and the other is Min Crz_OP. Have a look at page 9 of the EIS manual.
Min OilP is set at 22 and Max OilP is set at 98 for my 914. Note that Max OilP
must be set less than 99 - if it's set over 100 that may be your problem.
Jim Butcher
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=171300#171300
|