Hi! Alan
I haven't any fixing experience for you but best advice IMHO is don't go
near it with any form of heat gun unless you want it opaque instead of
see through!
Regards
Bob H G-PTAG
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of milnera
Sent: 27 August 2006 13:45
Subject: Europa-List: Distorted door window perspex
<alan_milner@totalise.co.uk>
I was just about to trim the door glass and noticed a horrid curl on the
stb top edge, particularly at the front. There is a small defect on the
port and the front screen is fine.
Has anyone experienced this before?
Some of the lip will obviously come off with trimming, but not enough.
Beyond attacking it with the hairdryer I'm not sure what do do?
Any ideas welcome.
There are a couple of photos here:
http://www.antsol.com/europaphotos.nsf/plinks/AMIR-6T3GNH
Alan
(XS trigear - booked in for painting in 5 weeks)
----------------
Visit EuropaOwnersForum http://www.europaowners.org/
|