Hi All,
I know that most have put some sort of rudder trim tab in place. My
questions are these. Should I put a couple of nut plates into the rudder
before I complete the filling and sanding of it? Which side is preferred?
How far up from the bottom? How big should it be? I am envisioning an
aluminum piece that will be bent to adjust later. Probably not as elegant as
it could be if molded in but you can't predict the angle needed in the
future. What to do???
Troy Maynor
N120EU Europa Monowheel Classic
Left to finish:
Paint,interior,engine install, wiring.
Weaverville, NC USA
|