Hi! Brian
To be rid of pin holes in Smooth Prime you use a "ragging"
Process.(trick!) whilst rollering when you see a pin hole you either use
the edge of your roller to scuff Smooth Prime into the hole and roller
over it or take a piece of lint free rag and scrub Smooth Prime into the
hole with your finger.
The beauty of Smooth Prime is that it is easy to cut back and can be
over rolled almost at will.
Use a spray can of black matt paint to put a mist all over the area to
be sanded and watch the low areas begin to show up as you sand.
Regards
Bob Harrison G-PTAG
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of
EuropaXSA276@aol.com
Subject: Re: Europa-List: Re: Finishing JIM
Why 6 coats of smooth prime? This product is rolled on?
Does it take 6 coats to cover the pin holes?
Knowing less than nothing about finishing.....
Brian Skelly
Texas
Europa # A276 TriGear
See My build photos at:
http://www.europaowners.org/BrianS
|