The roll pins in my case were tapered at each end and so positioned in the
holes ok. I then just tapped them in. By their nature they compress into the
hole and hold firm.
Alan
#0303
----- Original Message -----
From: "Tony Renshaw" <tonyrenshaw@optusnet.com.au>
Subject: Europa-List: Undercart Roll Pins
> <tonyrenshaw@optusnet.com.au>
>
> Gidday,
> Is there an easy way to place the 6 mm roll pin into the 4.8 mm holes in
> the LG 08s ??? Looks fairly impossible to me without opening up a tapered
> guide hole in the LG 08, but I don't want to do that without first asking
> around.
>
> Reg
> Tony Renshaw
> Sydney Australia
>
> Classic 236 B.B. Taildragger
> Tail, Wings, Ailerons, Flaps Complete and Connected
> Lower Fuse in Jig, and module most recently installed.
> Tail Torque Tube installed.
> Mass Balance assembly installed and deflections sorted
> Roof Panel between doors completed.
> Photos at:
> http://forum.okhuijsen.org/TonyR
> Intended Engine: 912S CS prop (model undecided)
> Instrumentation: Garmin 296 Colour GPS beneath an electronic Artificial
> Horizon, one that I can trust for short periods IMC, to get out of a
> sticky
> situation
>
>
>
|