Hi al,
Well I have powered up the Europa without smoke and flames and most things work.
I have a couple of questions.
Navaids. The internal gyro is loud. It runs smoothly but I was wondering how
much noise do they make.
TCU. This doesn't quite run as expected. On power up the servo cycles and
parks
it self, however the manual says that the warning and caution lights should
blink on for 1 ~ 2 seconds at power up. Mine don't, although the do come on
briefly when the unit is turned off. Is this correct ?
EIS. I expect that this will be a question for Grand Rapids, but here goes.
When
I set an parameter to generate an alarm the display flashes but the light
does not. The violet wire stays at 12v, I would expected that it should go to
ground at the same rate as the display flashes.
I'd appreciate some feed back from anyone who has had experience in these areas.
Thanks and regards, Paul
|