Hello Svein
My flap position sensor is mounted at one of the baggage bay support ribs. The
sensor pushrod is attached to an aluminum bracket, that I mounted onto the bolt,
which holds the flap drive pushrod's rear end and the flap drive tube together.
This setup leaves all the flap drive parts unchanged (no holes). As a picture
says more than a thousand words, I'll send you offline two pictures showing
my solution.
Regards,
Alfred
HB-YKI, XS Monowheel classic wings, wiring the panel
>>> sidsel.svein@oslo.online.no 12/21 3:46 >>>
To those who already have installed the RiteAngle AOA flap position sensor:
Where did you connect it to the flap mechanism?
It appears that a suitable point would be to fit the ball link to one of the
hinge arms (FL16), drilling the small diameter hole for it in the centre
line of the hinge arm as close as possible to the fuselage floor. This
should give the desired 90 degree rotation of the sensor. - Other
suggestions?
Seasons Greetings to all.
Svein
A225 - now in Norway
|