Keep cutting!
The top of the cut out on our XS is just above the joint line between upper
and lower mouldings - ie. we had to cut into the lower moulding joggle
slightly.
Regards
Paul Stewart #432
----- Original Message -----
From: "Alan Stills" <astills785@earthlink.net>
Subject: Europa-List: Tailplane Pitch
<astills785@earthlink.net>
>
> As I' ve just gone about setting the tailplane pitch to factory spec's of
+12 Deg Up and -4 Deg down, I've got a little problem. I can get plenty of
pitch down but have cut the opening ( for the trim tab rod) all the way up
to the "joggle" where the top and bottom mate and am reluntant to go any
further until I check an see if this is normal. I would have to cut
approximately another 1/2" up into the Joggle to achieve 12 deg up. I' ve
got approx 11 deg up to the botton of the joggle. What has been the
experience of some of you that have been there before me.
>
> Al Stills
> A095
>
>
|