Bob,
I sent the original, and if it saves you your paint it was worth it. To sum
up again, never use T-cut. On anything.
Ian G-BVVP
----- Original Message -----
From: "Bob Harrison" <ptag.dev@ukonline.co.uk>
Subject: "T" Cut and Polishes.
> Hi! All.
> Someone recently posted a message about the polish subject and sought to
> pass on good advice on this subject. I'm no authority but it prompted me
to
> take the question a little further than the "two pack or not question"
since
> there is two pack paints of cellulose and polyurethane and may be even
more
> .
> I have PRC-Desoto (was Courtaulds) CA 40,000 with UV protection in the top
> coat and I knew it was "two pack" because it had an "activator" for it.
> Having spoken to them the CA 40,000 is a Polyurethane two pack and should
> NOT have "T" cut applied to it. They recommend G3 Farecla from Brown
> Brothers ,Motor Factors. On speaking with them they wouldn't use "T" cut
on
> any kind of paint.
> I realise this message may duplicate the original one but since I had
> already deleted it I'm hoping you don't mind .
> Regards
> Bob Harrison G-PTAG
>
>
|