europa-list
[Top] [All Lists]

Re: Engine Thrustline

Subject: Re: Engine Thrustline
From: Tom & Cathy Friedland <tfriedland@home.com>
Date: Fri, 16 Mar 2001 14:12:32
Thanks Bob

You continue to amaze me by your willingness to help.

I don't know how to measure the rubber hardness but it seems pretty hard to me.
The male part has an "M" on it and the female part has the numbers "1039."

When you say to put the rubbers "back to front" do you mean to put the male
piece in the front and the female at the rear?  That is the opposite way shown
in the instruction manual which shows both upper and lower mounts installed the
same way.

Best Regards,

Tom Friedland

"Bob.Harrison" wrote:

> Hi! Guys.
> G-PTAG engine crank case looks down 0.2 of a degree relative to the Port
> side door cill. I am no authority on this but I believe the crank /prop
> centre line is 2" higher than the Rotax. I also think there should be 1/2
> degree offset but there again it may be 1.5 deg.!, which G-PTAG hasn't got
> therefore needing a small tab on the left/port rudder.
> I'm interested to know how stiff the rubber is on your engine mount rubbers.
> You will note from my examples on the "bin" web site that I had to put the
> top rubbers back to front? Don't forget to  do this , I would suggest it is
> logic which ever type of rubber you have. You need the static engine weight
> to pull the back plate ON TO THE RUBBER SPIGOT. The bottom one is OK for
> static load as the book instructs. I also made up a couple of the aluminium
> retaining bushes at 1/2" larger diameter for the top mounts. Looks much
> happier!
> Regards
> Bob Harrison  G-PTAG
>
> Regards
> Bob Harrison G-PTAG
>
> > -----Original Message-----
> > From: owner-europa@aztec.houxou.com
> > Subject: Re: Engine Thrustline
> >
> >
> > Hi, Tom --
> >
> > > I have a fwf kit for a Jabiru 3300 for the XS and thus far I have little
> > > installation info.  Does the Rotax kit 4 discuss the engine thrust
> > > line?  Many aircraft call for a 2 to 3 degree thrust line offset to
> > > starboard to compensate for P factor.  What is called for with the Rotax
> > > engines?
> >
> > 914 manual says 1.5 deg. to starboard.  Determined by a straightedge
> > on prop flange, with tick marks 20" on either side of centerline
> > (total 40").  Distance from marks to firewall should differ by
> > 1-1/16".
> >
> > >  Is there any vertical line offset?
> >
> > They don't say, but mine came out about zero.  It depends upon
> > relationship of your thrust centerline with the vertical position of
> > the aircraft's CG, probably still (desirably) above the latter for the
> > 3300, unlike a high-wing Cessna where engine's gotta point down.  I'd
> > guess as long it's zero or down a hair, you'll not notice anything in
> > flight testing (you don't want immediate pitch up on rapid power
> > application - horiz tail alone causes a bit of that).  Looks about
> > zero on Bob Harrison's, eh Bob?
> >
> > Enjoy that 3300.
> >
> > Regards,
> > Fred F., A063
> >
> >
>



<Prev in Thread] Current Thread [Next in Thread>