>
> Using Grahams carbon fibre bulk head and back plate helps stop the spinner
> going into a fit of the wobbles and exaggerating the problem.
>
> > I achieved this by following the approach that you have described.
> > Basically, there are three potential
> > sites for washers
>
> Using the outer six screws gives even more fine adjustment, washers can
be
> place either side of the offending blade, or nearer the heavy part of the
> spinner.
>
Sorry, I didn't make it clear. I *am* using the rear six screws. I just
didn't feel that I
would feel the difference between weights applied in front of, or behind the
emerging prop blade.
I *do* have the carbon fibre back plate.
alan
|