How much, at continuous use, amps are you pulling and what engine are you using? I ask because I have fitted a second second alternator to run all my toys Regards Frank Read this topic online here: h
So if your using the rotax external alternator that means youll have to modify the top cowl to put a bulge in it? Vertical Power planner to calculate the total current requirement based on that setup
So the rotax generator only puts out 18 amps max. There are three ways of attaching an alternator. 1 the rotax 40 amp option which runs off the prop flang via a belt but does not fit under the Europa
GRT hall sensor Pocket nets 6 AWG Cable All the above sold but the other parts are still available Read this topic online here: http://forums.matronics.com/viewtopic.php?p=478643#478643
Does anyone have the specifications of the seatbelts that are supplied by Europa? eg strength,flammability etc Many thanks Frank Read this topic online here: http://forums.matronics.com/viewtopic.php
Ill have the protective hood, number 34, for 33 please. Email me on spcialeffects@aol.com Many thanks Frank Read this topic online here: http://forums.matronics.com/viewtopic.php?p=479566#479566
Ill have the protective hood, number 34, for 33 please. Email me on spcialeffects@aol.com Many thanks Frank Read this topic online here: http://forums.matronics.com/viewtopic.php?p=479750#479750
It is my pleasure to announce that my aircraft, G-STUE, beat gravity for the first time this week with Pete Jeffers at the controls. Im forever indebted to Ivor Phillips for this time, knowledge and
Hi Phil. Have you considered the ultimate vents? They work very well Frank Xuereb Kit#165 Read this topic online here: http://forums.matronics.com/viewtopic.php?p=481131#481131
Cant you remove the arm, 1 bolt, clean the redux off, prep the tail wheel bar area for rebonding and refit then there is no real repair as your installing it again as per the manual. Frank Xuereb kit
Alan is correct in what he says. I take it you have a mono? If so let me share my experience with you. I have a mono and bleed the brake pushing fluid up from the bottom. However after 4 or 5 times o
Hello Clive, Frank here. I too asked this question awhile ago. http://forums.matronics.com/viewtopic.php?t=16768487&highlight Read this topic online here: http://forums.matronics.com/viewtopic.php?p=
Hi Graeme. You can get the redux in some tubes but youll need a gun too. https://www.silmid.com/adhesives/epoxy-adhesives/araldite-420a-b-adhesive-200ml/ Not sure about the ampreg stuff as its now a
Hi Dave. I found a local machine place, took the bolt with me and paperwork giving details and specs and they milled me a couple up for about 20 Regard Frank Xuereb kit #165 G-STUE Read this topic on
Hi all. Looking for a brake caliper for the mono. Please pm me with cost. Many thanks frank Read this topic online here: http://forums.matronics.com/viewtopic.php?p=488990#488990
Hi all. Looking for a brake caliper for the mono. Please pm me with cost. Many thanks frank Read this topic online here: http://forums.matronics.com/viewtopic.php?p=489097#489097