How about flex core, it's the stuff used to make the rear bulkhead, as you already said balsa wood will bond well too and you can shape it easily Regards craig
I started with the sides and blocked them down till the door was just fitting the hole, then did the top and bottom, the hinges were then fitted, as ron said the hinge rebates were junk, the door was
Try swapping the handles Hi all. Thanx for you help with door fitting - coming along nicely. As you can see I've got a problem with the doorlatch ? Despite following the instructions to the letter, w
Hate Facebook and twitter Regards craig Cheers, Having read about the manipulation of data on both of these, and their inherent limitations, I will not "sign into, subscribe or join" either of them -
I put a full wave loop antenna in to run a hand held scanner in mine a/c works a LOT better than the stubby antenna Get excellent reception afis, ground and atc at the nearest airport about 40km away
Tony, have a look at the link rod between the servo and the bell crank I had a long hard look at it and ended up shortening that link rod about 2mm, trimming the plastic will fix the issue, mine only
Sorry bud, me too if I am not too late Regards craig John, Sorry, I could not find the post when I checked this morning. You are on the list now. Regards, Bud Yerly -- Original Message -- From: nicol
While on the subject of the outer flap hinge, given its location, my thoughts were it might be advantageous to turn that hinge faring into a "fence" to help reduce spanwise flow. What say yee gentlem
I was pondering my panel today and its depth. My plan is to run a full glass panel, with a couple of "smart Single" units as Backups for ASI Alt etc. Given most of these units are now only about 5 in
Mine weigh about 25kg each without paint Does any one know the weight of Europa xs wings. To design W & B for trailer. Save me taking my wings off. Dave Park <http://www.avg.com/email-signature?utm_m
Ok thanks frank Hey Craig. Once you get all your wiring in, both in the panel and on the firewall, you will be struggling for space........that's what I found. Good luck Frank Xuereb, kit #165 Read t
My thoughts were to blend from near the front of the wing, around the flap hinge and blend back out near the back edge of the flap, which as you say would in effect fence the outer edge of the flap w
Just wondering if anyone has close up photos of the speed kit for the landing gear. I would like to see how it interfaces with The underside of the fuse and the bottom of the legs. Just wondering if
The interference drag was my concern also. My thoughts were to blend the top and bottom over about a 4 inch radius both fore and aft of the leg, and I figured modifying the kit Could take almost as l
Yes that is sort of what I was thinking, but a bit longer towards the L/E to really blend it nicely. As for the frontal area, or Flat plate area, I think I read (tried to find it again but cant) That
I came up with one idea, look up 5 CREE LED bike headlight on ebay. The units I got will run on voltage from 8 - 15 volts, one unit is about the same as my car headlight, they are about 2 inches acro
FYIW I installed the alloy elbow at build stage and used a commercial fuel tanker delivery hose to connect each end the supplier was willing To sell me half a metre, the spec sheet claimed it to be c