Just a thought, but if you really get stuck, you could cut down a radiator hose from a large car or small truck. Could well be cheaper too craig Checked by AVG - http://www.avg.com 7:16 AM
I have two, they are not andair's but yes i have one plumbed to main and one to reserve before the selector that way a switch to reserve ( which is standard op procedure for most if engine is running
You say you have shortened the CC, which means you MAY be ok with what you have. If you have shortened the stick 50%, then your movements would be down to 11.25cm f/A and 14cm Lat. The down side is y
How weird is that, the design is very close to one I was considering to scratch build before i started on my XS, glad to know it will fly ok, I didnt think anyone else would like such a departure fro
If you can get the tubes out again, easier said than do probably, I would suggest a shrink fit, if you are happy the insert tubes are the same size as the ID of the tubes after reaming then throwing
I had heard they were available but hadnt been able to find any in australia, I was looking at the dry charge race car batteries which come in at around 1.5kg 13.5volt 7Ah with about 200CCA cost is a
For those of you with completed AC or previous experience, I would like yo know what you use for supplimental O2 needs at say 15,000 ft. specifcally size of bottles, location, weight and how long the
Thanks for all the replies on and off list, the MH systems look quite good, with the on demand pulse system unless the law has been changed I am required to carry O2 at 10000 ft and required to use i
hard to say, I thought about it, that way if u need to make any changes you wont wreck your paint job, but to know you still haven't finished when you do your test flights would bug me I think, also
I came to the conclusion, that my fuselage must be about 20mm wider than it should be at the point where the blocks go rather than it being a fault with my measurements and CM install etc, as the win
I hadnt considered the wings being the issue, the inner rib on my wings are 12.5mm from the edge, but I would think that the distace from the spar bushing to the ring would be a more appropriate plac
A lot of the new tachs are able to work happily from an inductive pickup clipped to or wrapped around the HT cables, I have one that is so sensitive you dont even need the pickup touching the HT lead
Here's an idea for the new venture, a four seater kit, that uses the existing wings tail planes etc, so we can swap wings from two to four seats if desired. --Original Message-- From: owner-europa-li
I was planning on simmilar with a small venturi or simmilar to suck a light vaccuum on a line installed under the dash and then modify some small plastic cups to plug into the line if needed so you c
oh oh i know, shes not wearing any gloves to protect her hands :) Who needs one?...why not just hand-prop it? BTW, what's wrong with this picture? -- This message has been scanned for viruses and dan
congrats danny she looks great craig Well folks its finally happened. After six years of hard labour today at 11.20 G-c.e.r.i. at Caenarfon airport north wales UK. piloted by an officer and a gentlem
given you are adding more resin during the fill I was planning on AFTER filling, which wold make post cure the last job B4 you paint i guess. craig So tell me guys...is everyone post-curing BEFORE fi
I thought one of the reasons for post cure was also to stop your paint job --From crazing (lots of little micro cracks) which would require post cure of filler as well craig Fred - I had my control s
I believe a few have, to deal with CofG issues, rather than adding ballast to the rear they used the battery. Most seem to have run the cables under the door sill. If yours is a trike or conventional
Has anyone fitted in wing landing lights, other than the wing tip mounted type. I have been considering something like those employed on large airliners. Obviously not that large, but mounted inside