Hi Dan The original web article can be found here: http://curedcomposites.com/index.html or the page on finishing here: http://curedcomposites.com/finish.html Another good article on finishing is Way
Hi Dan A pdf attached of the "Epoxy Wipe" or "Skim Coating" method extracted from Wayne Hicks Cozy project. There is also lots of great finishing advice on this forum from Bud Yearly and the late gre
Hi Kyle A couple of pics of my installation. I think you have it spot on. I added some spiral wrap later to protect from chafing between the pipe, the rudder cables and wiring. -- Regards Kelv Weston
Hi Kyle Yes, oval PVC electrical conduit. Very thin wall - the type you bury in plastered walls. I secured at the back of the wheel well and aft of the baggage bay. I used one for the brake pipes, on
Hi All Clearing my garage, I have the following items available if anyone is interested, all unused and in original condition as supplied by Europa: 1) Adjustable NACA Scoop (x2) for fuselage sides -
Hi Rowland My cowl had been trimmed by Nev when I collected it and was as shown in the picture. I therefore assumed the intention was for the hinge to be riveted to the underside of the cowl and pane
Hi Graeme I have sent you a PM. -- Regards Kelv Weston Kit 497 kelv@kdweston.co.uk Read this topic online here: http://forums.matronics.com/viewtopic.php?p=511107#511107
Hi All I recently purchased new MT04 engine mounts from Europa. However, on examination, I noticed that the bolt hole and the raised ring that locates in the engine frame are not in the centre of the
Hi Brian My Europa is not flying yet and as the original mounts supplied with the kit were 12+ years old, I decided it would be prudent to replace with new items when I fitted the engine. A set was p
Hi Marcel I believe this is a fairly common problem if the fuselage has been parked in strong sunlight and got hot. If you are a Europa Club member, there is an article in the Europa Flyer No 68 tha